(how it works)

squzo.
fuzo.
presence.

There’s a balloon inside the head and a pump at the bottom. You squeeze, the air goes up the neck, the balloon comes out. That’s the whole mechanism.

Balloon coming out of the SquzoFuzo head

quick start guide →

Using it

Hold the figure by the pump and squeeze. Each squeeze pushes more air into the balloon. Stop whenever you like – let go and it rests again.

Balloons

Every set comes with one balloon pre-installed and 10 spare latex balloons. When you run out, any standard 5-inch (13 cm) latex balloon fits.

Safety

Not a toy. For adults only. Keep away from children: small parts and balloons are a choking hazard. Throw away broken balloons right away. Don’t inflate balloons near the face or eyes.

The balloons and the pump are natural rubber latex. If you have a latex allergy, don’t use them. The 3D printed parts are latex-free.

four steps

01squzo

Hold it by the pump and squeeze.

02fuzo

The balloons come out of the head.

03rest

Let go. It rests again.

04presence

It doesn’t need to do anything. It just needs to be there.

Height
170 mm
Width
55 mm
Body
3D printed PLA
Pump
Natural latex
Balloons
1 + 10 spare · natural latex
ready to
meet
squzofuzo?
Go to the SquzoFuzo Etsy shop